You jump into your car, get ready for your morning commute and turn the key to start the ignition – nothing happens. Second try – nothing. Looks like you have a dead battery to deal with. Even if you are a New driver or have many years of experience under your belt, a dead battery is inconvenient.
For many people, a dead car battery is all you need to reach for a phone call roadside assistance It is important for the company to know that this situation can be dealt with quite easily, while saving you time and money. With a set of jumper cables and another moving vehicle, you can potentially be back on the road in minutes. Continue reading for step-by-step instructions on how to safely use jumper cables, should this happen to you.
Step 1: Set up
The first step is to make sure that the vehicle with the dead battery and the vehicle you will use to jumpstart it are facing each other. It is also important to ensure that for vehicles with a manual transmission, you set the vehicle to neutral. For automatic, you want to set the vehicle to park. Finally, be sure to turn off both vehicles and set the parking brakes.
Step 2: Connect the cables
When handling jumper cables, remember that their function is to transfer electrical current from one vehicle to another. Once one end is connected to the car battery, you should never touch the other end except for the proper purpose. Safety glasses are recommended to protect your eyes from flying sparks. Connecting cables can seem intimidating at first but with a little know-how, it can be surprisingly easy. Here’s what you need to know:
- Once you open the hood of each vehicle, you need to locate the battery box. Locations may vary depending on the make and model of the vehicle, so it’s best to refer to your manual.
- Always make sure you can find the positive and negative terminals on the battery itself. These are usually seen as the colors “+” and “-” or red and black.
- Be sure to connect a red cable to the positive terminal on the dead battery. Then, connect the other red cable to the positive terminal on the working vehicle battery.
- Once the red cable is connected, you can move on to the black cable. Place a black cable on the negative terminal on a working vehicle battery.
- Do not connect the last black clamp to the dead battery. Instead, you attach it to an unpainted nut, bolt, or metal part on the vehicle.
Step 3: Let it charge
To start charging a dead battery, you will need to start the vehicle. Be sure to let it run anywhere from 30 seconds to a minute. Keep in mind the age of a dead battery as it may require more than a minute or two for the connection to work successfully. Older batteries take longer to charge.
Step 4: Attempt to start dead battery
To see if the dead battery is now charged, try starting the vehicle. If it doesn’t work right away, it may need a few extra minutes to charge. You may also need to try Lightly
Rebuilding a working vehicle engine. If that doesn’t work, now is the time to call your roadside assistance company, as they may need to come and help you in person.
Step 5: Disconnecting the cables
Once you’ve revived the dead vehicle, you’ll want to turn off both vehicles and disconnect the cables in the reverse order they were applied. Be careful not to let the clamps meet each other, especially if either of them is attached to the vehicle.
Step 6: Driving to recharge
At this point, you should be ready to a teeTake a short drive to charge your battery. Once the car is up and running, the alternator will charge the battery and make sure it doesn’t Once you turn it off it dies again.
As always, we know that safety must be a priority. To keep a
Car security kit It can come in handy when presented with a dead battery. To learn more about what you should have in your car safety kit, check out the link below!
